SPEED
o
MUTE
o
ON/OFF
o
Speakerphone – activated with ON/OFF button
•
MUTE – used with speakerphone, press to activate
•
Volume Controls – SPKR VOC for all speaker voice signals and RING VOL for all tone signals.
•
H-T-P Switch – Controls how intercom calls are received. H- Intercom call announce with
•
hands-free reply, T – Tone only intercom ringing, P – Call Announce intercom calls. Station
users calling your extension may override these settings using a dial code from their station.
Directory tray – slide out tray in the front of the terminal
•
Wall mounting – reversible base for standard wall jack mounting
•
DSS/DLS Console (Our Part Number VODAV1410-60) Features:
48 buttons to access stations, direct appearing CO lines or flexible buttons
•
Default Flex Features:
Camp-on – Alert a busy extension that an outside call is holding for them.
•
Line Queue – Puts your extension in line for an available outside line when one becomes
•
available.
Call Back – When you dial an extension and get a busy signal, use this feature to signal that
•
extension to ring your phone when idle again.
Pick Up – Allows you to pick up an incoming call that is ringing to an unattended station.
•
MSG Wait – Use to prompt a message waiting LED to light at an unavailable station.
•
PND – Forward your calls to another station.
•
DND – Places your telephone in Do Not Disturb mode. While in DND, you will receive no
•
calls, but may place calls as usual.
CONF – Place conference calls.
•
Fixed Feature Buttons:
HOLD – Places an outside call on hold.
•
TRANS – Transfer an outside call from one station to another.
•
FLASH – Ends an outside call and restores dial tone.
•
SPEED - Access speed dial, save number redial and last number redial.
•
MUTE – Switches the microphone or handset volume on or off, depending on whether you
•
are using the speakerphone or handset.
ON/OFF – Place a phone call without lifting the handset, turns speakerphone on and off.
•
Call Answering and Handling
Answer an Outside Call:
Lift handset or press ON/OFF to use speaker mode.
•
Press the flashing outside line button or loop button. If your station is programmed with
•
Preferred Line answer, this second step may be skipped.
Place an Outside Call on Hold:
For stations programmed for Exclusive Hold Preference, press HOLD for exclusive hold and
•
twice for system hold.
For stations programmed for System Hold Preference, press HOLD for system hold and twice
•
for exclusive hold.
Answering a Recall:
A call that has been holding too long will trigger a recall ring. To answer:
Courtesy of Main Resource, Inc. Visit us at
www.MainResource.com
your telecom needs.
or call 800 362-6740 for all