Siemens SINAMICS S120 Manual page 240

DC link components
5.1 Braking Module
Installing the Braking Module
Note
To install a frame size GX Braking Module in a frame size GB or GD Basic Line Module a
cable harness set is required, which is available under order number 6SL3366-2NG00-0AA0.
The steps for the installation procedure are numbered in accordance with the diagram.
1. Unscrew the three screws of the blanking plate.
2. Insert the Braking Module where the cover used to be and secure it using the three
3. Use the connecting cable in the cable harness set (order number 6SL3366-2NG00-
4. Secure the connecting cable to the DC link with two screws (Braking Module connection)
NOTICE
Pay attention to the tightening torques
The tightening torques specified in the table "Tightening torques for screw connections"
must be observed.
238
Remove the plate.
screws (from step 1).
0AA0).
and two nuts (DC-link connection).
Manual, (GH3), 01/2013, 6SL3097-4AE00-0BP3
Chassis power units