Napoleon NZ-26 Installation And Operating Instructions Manual page 23

6.2.3 The top and bottom fl ame spreaders come taped
together. This tape will burn away in the initial fi ring
of the appliance.
On subsequent brick removals, the bottom fl ame
spreader must be taped to the top spreader to ease
top brick and baffl e removal and to avoid damaging
the fi bre baffl es.
6.2.4a Insert the left fi brebaffl e, then the left top fi rebrick.
Repeat for the right side. Ensure the fi rebricks are
installed correctly otherwise they form a 'V' in the
center, overhang the baffl es and block the fl ue
gases.
NOTE: The baffl es are made of a brittle material.
Care must be taken not to bend or force them.
6.2.3b While holding the fi bre baffl es and fi rebricks in place,
replace the three front tubes and tube retainers.
Ensure the center edges of both baffl es and bricks
lie snugly together.
6.2.4 Position the baffl e support bracket into
place along the front of the appliance
between the front tube and the two top
fi rebricks as illustrated.
SECTION VIEW
TOP FLAME
SPREADER
BOTTOM
FLAME
SPREADER
REAR BRICKS
TOP
FIREBRICK
FIBRE
BAFFLE
23
BAFFLE
SUPPORT
BRACKET
W415-0676 / A / 06.07.10