Zoom; Adjusting The Tilt Feet - NEC PA622U User Manual

Zoom

Turn the zoom lever or zoom ring clockwise and counterclockwise.
• The separately sold NP11FL lens does not have a zoom ring.
Zoom ring

Adjusting the Tilt Feet

1. Turn the left and right tilt feet to adjust.
The tilt feet lengthen and shorten when turned.
The height of the projected image is adjusted by turning the left and
right tilt feet.
If the projected image is tilted, turn one of the tilt feet to adjust the
image so that it is level.
• If the projected image is distorted, see "3-6 Correcting Horizontal
and Vertical Keystone Distortion [CORNERSTONE]" (→ page 33)
and "[GEOMETRIC CORRECTION]" (→ page 87).
• The tilt feet can be lengthened by a maximum of 20 mm.
• The tilt feet can be used to tilt the projector by a maximum of 4º.
NOTE:
• Do not lengthen the tilt feet any more than 20 mm/0.8". Doing so will make the
tilt feet's mount section unstable and could cause the tilt feet to come off the
projector.
• Do not use the tilt feet for any purpose other than adjusting the projector's
projection angle.
Handling the tilt feet improperly, such as carrying the projector by grasping the
tilt feet or hooking it onto a wall using the tilt feet, could damage the projec-
tor.
2. Projecting an Image (Basic Operation)
Up
Tilt foot
23
Down