NEC PA622U User Manual page 128

Turning On the Projector By Applying Computer Signal [AUTO POWER ON SELECT]
This setting automatically projects any computer signal that is input when the projector is in the standby mode.
Connect to the input terminal on the projector using a cable and put the projector in the standby mode.
When using the [AUTO POWER ON SELECT], set the [STANDBY MODE] to [HDBaseT STANDBY], turn on the power
supply of the transmission device and keep it in a connected state.
OFF ������������������������ AUTO POWER ON SELECT function will be switch off�
HDMI1, HDMI2, DisplayPort, COMPUTER, HDBaseT
������������������������������ When a computer signal of a selected input terminal is detected, the power supply of the projector will be
turned on automatically and the computer screen will be projected�
NOTE:
• This function will not work for computer signals such as Sync on Green or Composite Sync and when component signals are
input to the computer or BNC video input terminal.
• If you want to test the AUTO POWER ON SELECT after switching off the power supply of the projector, wait for three or more
seconds first after switching off the power before inputting any computer signal. When the power supply is switched off and the
projector goes into the standby mode, the projector will continue to remain in the standby mode without power supply being
restored if a computer signal continues to be input to the projector.
Enabling Power Management [AUTO POWER OFF]
When this option is selected you can enable the projector to automatically turn off (at the selected time: 0:05, 0:10,
0:15, 0:20, 0:30, 1:00) if there is no signal received by any input or if no operation is performed.
NOTE:
• The power will not go off automatically when a signal from the Ethernet/HDBaseT port is being projected.
• [AUTO POWER OFF] appears in grey when the [STANDBY MODE] is set to [HDBaseT STANDBY] and [0:15] will be set automati-
cally.
Using Off Timer [OFF TIMER]
1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00, 16:00.
2. Press the ENTER button on the remote control.
3. The remaining time starts counting down.
4. The projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN 3
MINUTES] message will be displayed on the bottom of the screen.
115
5. Using On-Screen Menu