❷ Connecting Your Computer/Connecting The Power Cord - NEC PA622U User Manual

❷ Connecting Your Computer/Connecting the Power Cord
1. Connect your computer to the projector.
This section will show you a basic connection to a computer. For information about other connections, see "(2)
Making Connections" on page 125.
Connect the display output terminal (mini D-sub 15 pin) on the computer to the computer video input terminal on
the projector with a commercially-available computer cable (with ferrite core) and then turn the knobs of the con-
nectors to secure them.
2. Connect the supplied power cord to the projector.
First connect the supplied power cord's three-pin plug to the AC IN of the projector, and then connect the other
plug of the supplied power cord in the wall outlet.
Upon connecting the power cable, the POWER indicator of the projector will light up in orange. If there are no input
signals, the device will go into the standby mode after about 10 seconds and light up in red*.
The STATUS indicator will light off*.
* This will apply for both indicators when [NORMAL] is selected for [STANDBY MODE]. See the Power Indicator
section. (→ page 173)
CAUTION:
Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if the
AC power supply is disconnected during normal projector operation.
Use caution when picking up the projector.
Computer cable (with ferrite core)
(sold commercially)
13
2. Projecting an Image (Basic Operation)
COMPUTER IN
Make sure that the prongs are fully inserted into
both the AC IN and the wall outlet.
To wall outlet