Before using the machine
3
Load the paper into the right side of the tray 4 (LCT) so that the
side of the paper to be printed on (the side facing up when the
package was unwrapped) faces up.
–
Load letterhead paper so that the side to be printed on
faces down.
–
To print on OHP transparencies, thick paper 4, envelopes
or postcards, use the tray 1.
?
How is curled paper loaded?
% Flatten the paper before loading it.
4
Load the paper into the left side of the tray 4 (LCT) so that the
side of the paper to be printed on (the side facing up when the
package was unwrapped) faces up.
5
Close the tray 4 (LCT).
–
If special paper is loaded, the paper type setting must be specified. For details, refer to "Paper
Settings Menu" on page 9-17.
Reminder
Be careful not to touch the film.
Do not load so many sheets of paper that the top of the stack is higher than the , mark.
For details on the paper that can be loaded into the tray 4 (LCT), refer to "Paper" on page 2-20.
Note
If the machine has entered Low Power mode or Sleep mode, the tray 4 (LCT) cannot be pulled out, even
after the tray release button is pressed. Be sure to first cancel Low Power mode or Sleep mode.
magicolor 8650
EDNord - Istedgade 37A - 900 Aalborg - telefon 9633 3500
, mark
Film
, mark
2
2-31