Chicago Electric 95189 Operating Instructions Manual page 19

iNSPEcTiON, MAiNTENANcE, AND cLEANiNG
1. cAuTiON! Always make sure the Engine Power Switch (2) is in its "OFF" position.
Disconnect the spark plug wire from the engine and allow sufficient time for the
Engine and Generator to completely cool before performing any inspection, main-
tenance, or cleaning.
2. Before each use,
loose screws, misalignment or binding of moving parts, cracked or broken parts, loose hose
connections, and any other condition that may affect the safe operation of the Generator
and Engine. If abnormal noise or vibration occurs, have the problem corrected before
further use. Do not use damaged equipment.
3. Follow all maintenance procedures as outlined in the
below at the specified intervals. In addition, observe the following details:
Before each use: check to make sure the Engine's oil level is adequate. If necessary, fill
the Engine's Crankcase until the oil level is even with the Oil Fill Hole.
Before each use: with a soft brush, sloth, or vacuum, remove all debris from the Generator
and Engine. Then, use a premium quality, lightweight machine oil to lubricate all moving
parts.
After the inital 20 hours of use and every 100 hours of use thereafter: drain the old
Engine oil and replace with approximately 3/4 (0.63) quart of a high quality SAE 10W-30
grade engine oil.
4. Alway keep fuel tank capped, even when empty, to prevent rainwater, dirt and debris from
getting into the fuel tank.
SKU 95189 For technical questions, please call 1-800-444-3353.
inspect the general condition of the Generator and Engine. Check for
Engine Maintenance Schedule
REV 09a
Page 19