Appendix A - Printed Form For User Defined Parameter Settings - Hitachi L100 IP Series Instruction Manual

Appendix A – Printed form for user defined parameter
L100IP series inverters provide many functions whose parameters can be set by the user. It is recommended
that the parameters that have been set by the user be recorded to speed the investigation and repair in the
event of a failure. You can use one of the "Set value" columns that have been provided in this chapter for
your convenience.
If the information in the column "Function" should not provide a sufficient explanation you can still use the
extensive function descriptions contained in chapter 8 "Using the digital operator".
L100IP
Serial No.
Display
F 01 Frequency set value
Acceleration time 1 (in s)
F 02
F 03 Deceleration time 1 (in s)
F 04 Motor direction
Display
Frequency set value source
A 01
00-NOT IN USE 01-Input O/OI
02-Functions F 01 / A 20
A 02 Run command source
01-Input FW/RV 02-RUN key
A 03 Base frequency
A 04 Maximum frequency
External frequency start point
A 11
A 12 External frequency end point
A 13 External frequency start point bias (in %)
A 14 External frequency end point bias (in %)
External frequency start pattern
A 15
00-According to A 11 and A 13 01-0Hz
A 16 Analog input filter time constant
Frequency set value ( A 01 must be = 02)
A 20
A 21 1. Multistage frequency setting
A 22 2. Multistage frequency setting
A 23 3. Multistage frequency setting
A 24 4. Multistage frequency setting
A 25 5. Multistage frequency setting
A 26 6. Multistage frequency setting
A 27 7. Multistage frequency setting
A 28 8. Multistage frequency setting
9. Multistage frequency setting
A 29
A 30 10. Multistage frequency setting
A 31 11. Multistage frequency setting
A 32 12. Multistage frequency setting
A 33 13. Multistage frequency setting
14. Multistage frequency setting
A 34
A 35 15. Multistage frequency setting
Appendix A – Printed form for user defined parameter settings
settings
This information is written on the
nameplate located on the bottom side
of the L100IP inverter.
Function
Function
Standard
setting
0.0
10.0
10.0
00 (forward)
Standard
setting
01
01
-FE: 50
-FU: 60
0
0
0
100
01
8
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
A-1
S e t v a l u e
S e t v a l u e