Special Tools - Yamaha CS50 Service Manual

EAS00027

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools; this will help prevent damage caused by the use of inappropria-
te tools or improvised techniques.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No.
90890-01235
90890-01337
90890-01274
-01275
-01277
-01288
90890-01362
.
90890-01135
90890-01384
90890-01403
90890-01701
90890-03079
Tool name / Usage
Rotor holding tool
This tool is used to remove the flywheel
magneto.
Clutch spring bracket
This tool is used to remove the clutch nut
while holding the compression spring.
Container of the crankshaft installer a
Bolt of the crankshaft installer b
Adapter c, Spacer d
These tools are used to install the
crankshaft.
Flywheel puller
For removing the flywheel.
Crankcase separation tool
This tool is used to remove the
crankshaft or separate the crankcase.
Oil seal guide
Protects the edge of the oil seal during
the installation of the secondary sliding
pulley wheel.
Ring nut wrench
This tool is used to loosen and tighten
the steering ring nut.
Pulley bracket
This tools is used to disassemble and
assemble the secondary pulley.
Thickenss gauge
This tool is used to measure the clearance.
SPECIAL TOOLS
1-4
GEN
INFO
Illustration