Installation Points To Remember; Tools Required - Auto Mate 435 Installation Manual

installation points to remember

This product represents many years of research and development. It is very sophisticated and should be installed
by experienced security installers only. Please do not attempt installation of this product without reading this
guide. The system has been designed to provide the ultimate in security, coupled with limitless convenience and
expansion options.
This product is not intended for consumer installation and will have NO WARRANTY unless it is installed by an
authorized dealer.
Do not disconnect the battery if the vehicle has an anti-theft coded radio. If equipped with an airbag, avoid dis-
connecting the battery if possible.
IMPORTANT! Many airbag systems will display a diagnostic code through their warning light after
they lose power. Disconnecting the battery requires this code to be erased, a procedure that can
require a trip to the dealer.
Before beginning the installation:
I Check with the customer to determine the Status LED location.
I Remove the domelight fuse. This prevents accidentally draining the battery.
I Roll down a window to avoid being locked out of the car.
After the install:
I Test all functions. The "Using Your System" section of the Owner's Guide is very helpful when testing.
I When testing, don't forget that this system is equipped with Nuisance Prevention
both instant trigger zones, making them seem to stop working.

tools required

I Digital multi-meter
I Wire cutters/strippers
I Solderless terminal crimpers
I Cordless power drill
I Torx driver set
This is a general list of tools required to complete the installation of this DEI
Some vehicles may require additional tools.
4
I Nutdriver and/or socket set
I Panel removal tool
I Drill bit set
I Phillips head screwdriver
I Work light
® security system in most vehicles.
© 1999 Directed Electronics, Inc. Vista, CA
® Circuitry. NPC ™ can bypass