Table of Contents
Advertisement
H3/2 VIOLET/BLACK (-) 200 mA channel 4 output
This wire supplies a 200mA (-) output whenever the button(s) controlling Channel Four is pressed and will con-
tinue until the button(s) is released. This output can be used to control optional accessories.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! This
transistorized output can only supply 200 mA (-), and connecting directly to a solenoid, motor, or
other high-current device will cause the module to fail.
plug-in harnesses
super-bright LED, 2-pin white plug
The super bright LED operates at 2V DC. Make sure the LED wires are not shorted to ground as the LED will be
damaged. The LED fits into a
ing hole.
valet/program switch, 2-pin blue plug
The Valet
®
/Program switch should be accessible from the driver's seat. It plugs into the blue port on the side of
the unit. Since the system features Valet
will be used for before choosing a mounting location. Check for rear clearance before drilling a
mounting the switch.The GRAY wire in the two-pin plug may also be used as a (+) Ghost switch
be connected to any (+) switch in the vehicle. (See Feature Descriptions section of this guide.)
NOTE: Please note for the customer the location of the Valet
vided in the Owner's Guide.
data input port, 3-pin black port
The black three-pin port can be used for programming the unit or to accommodate a serial controller. When using
the optional DEI Bitwriter
figure any or all of the programmable functions using an IBM-compatible personal computer. When using a serial
controller, such as DEI's 103T Keypad or the DEI 400A Car#Com, basic operating functions can be controlled
without the use of a remote transmitter. For more information please refer to the guides packaged with these DEI
compatible products.
© 1999 Directed Electronics, Inc. Vista, CA
9
/
-inch mounting hole. Be sure to check for clearance prior to drilling the mount-
32
by remote, the switch can be well hidden. Consider what the switch
®
™
or PC Interface module (DEI part number 996T) for programming, it is possible to con-
®
/Program switch in the section pro-
9
/
-inch hole and
32
™
input and can
27
Advertisement
Chapters
Table of Contents
