On-Board Doubleguard Shock Sensor; Auxiliary Harness (H3), 2-Pin Connector - Auto Mate 435 Installation Manual

on-board doubleguard shock sensor

There is a Doubleguard
cated above. Since the shock sensor does not work well when mounted firmly to metal, we recommend against
screwing down the control module. The full trigger of the on-board shock sensor reports zone 2. (See Table of
Zones section of this guide.)
NOTE: When adjusting the sensor, it must be in the same mounting location that it will be after
the install is completed. Adjusting the sensor and then relocating the module requires readjust-
ment.

auxiliary harness (H3), 2-pin connector

H3/1 BROWN (-) horn honk output
This wire supplies a 200 mA (-) output that can be used to honk the vehicle's horn. It provides a pulsed output
when the security system is in the triggered sequence or in panic mode. In most vehicles with (-) horn circuits
this wire can control the vehicle's horn without adding a relay. If the vehicle has a (+) horn circuit, an optional
relay must be used to interface with the horn circuit.
26
® shock sensor inside the control unit. Adjustments are made via the rotary control as indi-
© 1999 Directed Electronics, Inc. Vista, CA