H1/9; H1/10; H1/11; H1/12 - Auto Mate 435 Installation Manual

H1/9 YELLOW (+) ignition input
Connect this wire to the (+)12V ignition wire. This wire must show (+)12V with the key in Run position and during
cranking. Take care to insure that this wire cannot be shorted to the chassis at any point.
H1/10 BROWN (+) siren output
Connect this to the red wire of the siren. Connect the black wire of the siren to (-) chassis ground, preferably at
the same point you connect the control module's black ground wire.
H1/11 RED (+) 12V constant power input
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant 12V supply
to the ignition switch.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A fuse
in the harness for this purpose. This fuse protects the module itself.
H1/12 RED/WHITE 200 mA (-) channel 2 output
When the system receives the code controlling Channel Two for longer than 1.5 seconds, the red/white will supply
an output as long as the transmission continues. This is often used to operate a trunk/hatch release or other
relay/driven function.
18
© 1999 Directed Electronics, Inc. Vista, CA