Assembly - CYBEX 12231-999-4 C Owner's And Service Manual

TOOLS REQUIRED
• 7/32" Allen wrench
• 1/8" Allen wrench
• Medium weight automotive engine oil
• Torque wrench
• 3/4" Wrench
• Tape measure
NOTE: Two people will be required for this procedure.
NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is appropriate
clearance around each machine toallow for safe use and passage.
NOTE: Refer to chapter 6 for reference diagrams.
1. Read and understand all instructions thoroughly before starting any of the procedures
listed on this instruction sheet.
2. Verify you have received the appropriate confi guration.
A. Verify that you received the correct color machine that you ordered.
B. Verify you received the proper weight stack.
C. Verify you received the appropriate owner's manual.
D. Verify you received the warranty sheet.
3. Move to desired location.
4. Remove shipping feet.
WARNING: Use extreme caution when removing shipping cones and installing feet.
Failure to do so could result in injury.
A. With an assistant, carefully remove each (standard) cone-shaped shipping support
using a 3/4" socket or wrench.
B. Cut shipping tie securing top weight.
C. Carefully place rubber feet (supplied with machine) on each foot of the frame.
5. Install chin handle.
A. Carefully remove hardware kit, chin handle and support
leg secured to frame. With an assistant, carefully lift
chin handle onto dip handle. See Figure 1.
B. Align holes with connection plate. See Figure 1.
NOTE: If holes do not line up then loosen the 12 Button
Head Socket Cap Screws (BHSCS) securing dip handle
to frame.
C. Apply loctite #242 to the BHSCS (supplied in hardware
kit). NOTE: BHSCS .375-16 x .625 are installed on
the inside of connection plate. BHSCS 3.75-16 x .875
are installed on the outside of connection plate.
See Figure 1.
Cybex VR3 12231 Dip/Chin Assist Owner's Manual

4 - Assembly

BHSCS
.375-16 x .875 (6)
Dip Handle
Figure 1
Chin Handle
BHSCS .375-16 x
.625 (6)
Connection
Plate
Assembly
Page 4-1