Assembly; Tools Required - CYBEX Plate Loaded 16210 Seated Calf Owner's And Service Manual

Tools Required

• 3/4" Wrench
NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is appropriate clearance
around each machine to allow for safe use and passage.
NOTE: Refer to chapter 6 for reference diagrams.
1. Read and understand all instructions thoroughly before starting any of the procedures listed on this
instruction sheet.
2. Verify you have received the appropriate confi guration.
A. Verify that you received the correct color machine that you ordered.
B. Verify you received the appropriate owner's manual.
C. Verify you received the warranty sheet.
3. Move to desired location.
A. Note the diminsions of the machine:
Machine Weight: 147 lbs. Size: 30 W" x 58" L x 39" H
Machine Weight: 87 kg. Size: 76 cm W x 147 cm L x 99 cm H
B. Carefully remove shrink wrap securing rubber feet.
C. Carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench.
D. Carefully place rubber feet (supplied with machine) on each foot of the frame.
4. Anchor machine to fl oor.
A. Securely anchor machine to the fl oor using the anchor holes provided in each machine.
NOTE: Cybex is not responsible for the actual anchoring of equipment. Consult with a professional contractor.
NOTE: Use fasteners having a minimum of 500 lbs. tensile capacity (3/8" grade 2 bolts or better).
NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in contact with
surface using fl at washers.
5. Verify proper operation.
Cybex Plate Loaded 16210 Seated Calf Owner's Manual

4 - Assembly

Page 7