CYBEX 12231-999-4 C Owner's And Service Manual page 22

C. Install but do not tighten remaining BHSCS securing shroud.
D. Tighten all BHSCS.
10. Install weight plate decals.
A. Slowly and carefully peel off back side of decal.
peeling off back cover, make sure that the decals remain
attached to the front sticker. Figure 6.
B. Insert a guide pin through each hole of the template.
NOTE: A guide pin can be anything that fi ts through
the weight stack hole, such as a weight stack
selector pin.
C. Carefully align decal and rub it onto weight plates.
D. Carefully remove front side, leaving decals adhering
to weight plates. See Figure 7.
NOTE: It is important that you perform regular inspection
and maintenance activities on your equipment.
See the CYBEX VR3 Owner's Manual for
inspection and maintenance activities. If you do
not have a CYBEX Owner's Manual or if you have
any questions or concerns, call CYBEX Customer
Relations at 1-800-766-3211.
11. Verify proper operation
12. Securely anchor machine to the fl oor.
A. Securely anchor machine to the fl oor using the anchor holes provided in each machine.
NOTE: Cybex is not responsible for the actual anchoring of equipment. Consult with a professional contractor.
NOTE: Use fasteners having a minimum of 500 lbs. tensile capacity ( 3/8'' grade 2 bolts or better).
NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in
contact with surface using fl at washers.
Assembly
Page 4-4
Cybex VR3 12231 Dip/Chin Assist Owner's Manual
NOTE: When
Front
Back
Figure 6
Guide Rod
Weight Stack
Pounds
Figure 7
9 .0
2 0
1 8 .0
4 0
6 0
3 6 .0
8 0
4 5 .0
1 0 0
Kilograms
5 4 .0
1 2 0
6 3 .0
1 4 0
7 2 .0
1 6 0
8 1 .0
1 8 0
9 0 .0