Show Stp - D-Link DGS-3000 Series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
<value 6-40> - Enter the maximum age value here. This value must be between 6-40.
maxhops - (Optional) Specifies to restrict the forwarded times of one BPDU. The default value is
20.
<value 6-40> - Enter the maximum hops value here. This value must be between 6 and 40.
hello_time - (Optional) The time interval for sending configuration BPDUs by the Root Bridge.
The default value is 2 seconds. This parameter is for STP and RSTP version. MSTP version
uses per-port hellotime parameter.
<value 1-2> - Enter the hello time value here. This value must be between 1 and 2.
forwarddelay - (Optional) The maximum delay time for one BPDU to be transmitted by a bridge
and received from another bridge. The default value is 15.
<value 4-30> - Enter the maximum delay time here. This value must be between 4 and 30.
txholdcount - (Optional) Specifies to restrict the numbers of BPDU transmitted in a time interval.
<value 1-10> - Enter the transmitted BPDU restriction value here. This value must be
between 1 and 10.
fbpdu - (Optional) Specifies whether the bridge will flood STP BPDU when STP functionality is
disabled.
enable - Specifies that the bridge will flood STP BPDU when STP functionality is disabled
disable - Specifies that the bridge will not flood STP BPDU when STP functionality is disabled
nni_bpdu_addr - (Optional) Specifies to determine the BPDU protocol address for GVRP in
service provide site. It can use 802.1d GVRP address, 802.1ad service provider GVRP
address or an user defined mutilcast address. The range of the user defined address is
0180C2000000 - 0180C2FFFFFF.
dot1d - Specifies that the NNI BPDU protocol address value will be set to Dot1d.
dot1ad - Specifies that the NNI BPDU protocol address value will be set to Dot1ad.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure STP:
DGS-3000-26TC:admin#config stp maxage 25
Command: config stp maxage 25
Success.
DGS-3000-26TC:admin#
51-4

show stp

Description
This command is used to show the bridge parameters global settings.
Format
show stp
Parameters
None.
481