Chapter 14 Compound Authentication Command List - D-Link DGS-3000 Series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Chapter 14 Compound Authentication
enable authorization attributes
disable authorization attributes
show authorization
config authentication server failover [local | permit | block]
show authentication
14-1 enable authorization
Description
This command is used to enable authorization. When authorization for attributes is enabled, the
authorized attributes (for example VLAN, 802.1p default priority, and ACL) assigned by the
RADIUS server or local database, will be accepted depending on the individual module's settings.
Authorization for attributes is enabled by default.
Format
enable authorization attributes
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example sets authorization global state enabled:
DGS-3000-26TC:admin#enable authorization attributes
Command: enable authorization attributes
Success.
DGS-3000-26TC:admin#
14-2 disable authorization
Description
This command is used to disable authorization. When authorization for attributes is disabled, the
authorized attributes (for example VLAN, 802.1p default priority, and ACL) assigned by the
Command List
139