Show Stp Ports - D-Link DGS-3000 Series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
hellotime - (Optional) The default value is 2 . This parameter is for MSTP version. For STP and
RSTP version, uses the per system hellotime parameter.
<value 1-2> - Enter the hello time value here. This value must be between 1 and 2.
migrate - (Optional) Operation of management in order to specify the port to send MSTP BPDU
for a delay time.
yes - Specifies that the MSTP BPDU for a delay time will be sent.
no - Specifies that the MSTP BPDU for a delay time will not be sent.
edge - (Optional) To decide if this port is connected to a LAN or a Bridged LAN.
true - Specifies that the specified port(s) is edge.
false - Specifies that the specified port(s) is not edge.
auto - In auto mode, the bridge will delay for a period to become edge port if no bridge BPUD
is received. The default is auto mode.
p2p - (Optional) To decide if this port is in Full-Duplex or Half-Duplex mode.
true - Specifies that the port(s) is in Full-Duplex mode.
false - Specifies that the port(s) is in Half-Duplex mode.
auto - Specifies that the port(s) is in Full-Duplex and Half-Duplex mode.
state - (Optional) To decide if this port supports the STP functionality.
enable - Specifies that STP functionality on the port(s) is enabled.
disable - Specifies that STP functionality on the port(s) is disabled.
restricted_role - (Optional) To decide if this port not to be selected as Root Port. The default
value is false.
true - Specifies that the port can be specified as the root port.
false - Specifies that the port can not be specified as the root port.
restricted_tcn - (Optional) To decide if this port not to propagate topology change. The default
value is false.
true - Specifies that the port can be set to propagate a topology change.
false - Specifies that the port can not be set to propagate a topology change.
fbpdu - (Optional) To decide if this port will flood STP BPDU when STP functionality is disabled.
When the state is set to enable, the received BPDU will be forwarded. When the state is set to
disable, the received BPDU will be dropped.
enable - Specifies that the port can be set to flood the STP BPDU when the STP functionality
is disabled.
disable - Specifies that the port can not be set to flood the STP BPDU when the STP
functionality is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure STP ports:
DGS-3000-26TC:admin#config stp ports 1 externalCost auto
Command: config stp ports 1 externalCost auto
Success.
DGS-3000-26TC:admin#

51-12 show stp ports

Description
This command is used to show the port information includes parameters setting and operational
value.
487