Symbologies 13-13
UPC/EAN/JAN Supplemental Redundancy
With Autodiscriminate UPC/EAN/JAN Supplementals selected, this option adjusts the number of times a symbol without
supplementals is decoded before transmission. The range is from two to thirty times. Five or above is recommended when decoding
a mix of UPC/EAN symbols with and without supplementals, and the autodiscriminate option is selected. The default is set at 7.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in
Appendix D, Numeric Bar
Codes.
Single digit numbers must have a leading zero. To correct an error or change a selection, scan Cancel on page D-4.
UPC/EAN/JAN Supplemental Redundancy
Transmit UPC-A Check Digit
The check digit is the last character of the symbol used to verify the integrity of the data. Scan the appropriate bar code below to
transmit the bar code data with or without the UPC-A check digit. It is always verified to guarantee the integrity of the data.
*
Transmit UPC-A Check Digit
Do Not Transmit UPC-A Check Digit
Transmit UPC-E Check Digit
The check digit is the last character of the symbol used to verify the integrity of the data. Scan the appropriate bar code below to
transmit the bar code data with or without the UPC-E check digit. It is always verified to guarantee the integrity of the data.
*
Transmit UPC-E Check Digit
Do Not Transmit UPC-E Check Digit