Removing/Installing the Back Upholstery Cover, Adjustable Tension
Back Upholstery and Lumbar Strap
NOTE: For this procedure, refer to FIGURE 6.5.
NOTE: If replacing the back upholstery cover, adjustable tension back upholstery and/or lumbar
strap, remove the existing upholstery/lumbar strap and install the new upholstery/lumbar strap.
Removing the Back Upholstery Cover
1. Remove the seat cushion, if applicable.
2. Pull the back upholstery cover away from the adjustable tension back upholstery
separating the fastening strips of the back upholstery cover from the fastening strips
of the adjustable tension back upholstery and seat (Details "A" and "B").
3. Remove back upholstery cover from wheelchair.
Removing the Adjustable Tension Back Upholstery
1. Remove the back upholster cover. Refer to Removing the Back Upholstery Cover.
2. Slide adjustable tension back upholstery off back canes (Details "C" and "D").
Removing the Lumbar Strap
1. Remove the back upholster cover. Refer to Removing the Back Upholstery Cover.
2. Fold back forward. Refer to Unfolding/Folding the Back on page 30.
3. Loosen the top mounting screw but DO NOT remove (Detail "E").
4. Remove the lower mounting screw, coved spacer, washer and locknut from each back
cane (Detail "E").
5. Slide lumbar strap off back canes (Details "D" and "E").
Installing the Lumbar Strap
1. Install lumbar strap (Details "D" and "E").
2. Install lower mounting screw, coved spacer, washer and locknut onto each back cane
(Detail "E").
3. Tighten the top and bottom mounting screws (Detail "E").
4. Return back to upright position. Refer to Unfolding/Folding the Back on page 30.
5. Install the back upholstery. Refer to Removing the Back Upholstery Cover
Installing the Adjustable Tension Back Upholstery
1. Install the adjustable tension back upholstery onto the back canes
(Details "D", "F", and "A").
Part No 1134343
35
SECTION 6—BACK
™
Crossfire
T6A Wheelchair