Removing/Installing The Camber Tube; Removing The Camber Tube; Installing The Camber Tube - Invacare TOP END Crossfire T6A Owner's Operator And Maintenance Manual

SECTION 9—WHEELS

Removing/Installing the Camber Tube

Camber tube clamps - Make sure the clamp screws are securely tightened before
using the wheelchair, otherwise personal injury or damage to the wheelchair may
occur.
NOTE: For this procedure, refer to FIGURE 9.11.

Removing the Camber Tube

1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 45.
2. Loosen the two socket head clamp screws securing camber tube to the two camber
tube clamps.
3. Slide the camber tube through he camber tube clamps.

Installing the Camber Tube

1. Insert the camber tube into the camber tube clamps.
2. Center the camber tube in the camber tube clamps.
3. Adjust the camber tube. Refer to Adjusting the Camber Tube on page 55.
NOTE: There are four types of camber tubes: 0°, 3°,6° and 9°. If the camber tube being used is 3°,6°
or 9° degrees, then the camber tube MUST be rotated so that the axle bushings at the ends of camber
tube are angled up (Detail "A"). Installing the camber tube in any other orientation will directly
impact the angle of the rear wheel.
Camber Tube
Clamp
Socket Head
Clamp Screw
Camber Tube
FIGURE 9.11 Adjusting Wheelbase Length, Adjusting Center of Gravity (COG)
™
Crossfire T6A Wheelchair
WARNING
DETAIL "A" - CORRECT ORIENTATION FOR
EACH CAMBER TUBE
0° angle
Axle
Bushing
Camber
Tube
Clamp
Socket Head Clamp Screw
54
3 ° angle
Camber
Tube
6° angle
9° angle
Part No 1134343