Table of Contents
Advertisement
6.9 Cushion Covers
6.9.1 Removing/Installing the Seat Cushion Cover
1.
Pulling up to release the hook and loop strips A, remove the
seat cushion B to the seat pan C.
2.
Open the fold along the bottom of the seat cushion.
3.
Remove the seat cushion cover from the seat cushion.
4.
Reverse STEPS 1-3 to reinstall the seat cushion cover.
6.9.2 Removing/Installing the Back Cushion Cover
Pulling the back cushion D towards the front of the personal
1.
transporter to release the hook and loop strips E, remove the
back cushion from the back pan F.
2.
Open the fold along the bottom of the back cushion.
3.
Remove the back cushion cover from the back cushion
4.
Reverse STEPS 1-4 to reinstall the back cushion cover.
1580058-B
Adjusting the mobility device to the user's seating posture
6.9.3 Cleaning the Cushion Covers
CAUTION!
– Machine wash cold. Gentle cycle. Mild detergent. No
fabric softeners or bleach.
– DO NOT machine dry. Air dry ONLY out of sun.
6.10 Adjusting Forks
This procedure must be performed by a qualified technician.
This procedure applies to both Forks.
1.
Remove the head tube cover A from the caster head tube B.
2.
To properly tighten caster journal system and guard against
flutter, perform the following check:
a.
Tip the personal transporter forward, toward the floor.
Pivot both forks C and casters to top of their arc
b.
simultaneously.
c.
Let casters drop to bottom of arc (wheels should swing once
to one-side, then immediately rest in a straight downward
position).
Adjust locknuts D according to freedom of caster swing.
d.
35
Advertisement
Table of Contents
