THOMSON TG580 Setup And User Manual page 72

6 Thomson Gateway GUI
1 Select/clear the Use Address Based Filter check box.
2 Click Apply.
If your administrator account is configured as default user, make sure you configure a
password for this account or change the default user. Otherwise any user on your local network
can browse to your Thomson Gateway to disable your filtering rules.
For more information, see also
user" on page
Add Address Based Filtering rules:
Before you can perform the following actions, make sure that Address Based Filtering is enabled.
Block all Web sites and allow some Web sites, proceed as follows:
1 In the Action for unknown sites list, select Block.
2 Click Apply.
3 In the Web Site text box type the URL of the Web site you want to allow.
4 In the Action list, select Allow.
5 Click Add.
6 Repeat steps 3 to 5 for every URL you want to allow.
Allow all Web sites and block some Web sites, proceed as follows:
1 In the Action for unknown sites list, select Allow.
2 Click Apply.
3 In the Web Site text box type the URL of the Web site you want to block.
4 In the Action list, select Block.
5 Click Add.
6 Repeat steps 3 to 5 for every URL you want to block.
Edit or delete Address Based Filtering rules:
To delete or edit a address based filtering rule, click respectively Edit or Delete after the rule you want to
edit or delete.
66
"6.3.8 User Management" on page 73
75.
and " Adding a new
E-DOC-CTC-20090507-0002 v1.0