Engine Oil - Yamaha 2009 YW125Y Owner's Manual

Engine oil<IXE>
TIP
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4 ~ 1/2 turn
past finger tight. However, the spark plug
should be tightened to the specified
torque as soon as possible.
4. Install the spark plug cap.
5. Install the panel.
PERIODIC MAINTENANCE AND ADJUSTMENT

Engine oil

The engine oil level should be checked
before each ride. In addition, the oil must
be changed and the oil strainer cleaned
at the intervals specified in the periodic
maintenance and lubrication chart.
To check the engine oil level
1. Place the vehicle
centerstand. A slight tilt to the side
can result in a false reading.
2. Start the engine, warm it up for sev-
eral minutes, and then turn it off.
1
1. Oil filler cap
2. Maximum level mark
3. Minimum level mark
6-47 6-10
EAUT2592 3. Wait a few minutes until the oil
settles, remove the oil filler cap,
wipe the dipstick clean, insert it
back into the oil filler hole (without
screwing it in), and then remove it
again to check the oil level.
TIP
The engine oil should be between the
on the
minimum and maximum level marks.
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil
1. Start the engine, warm it up for sev-
2
eral minutes, and then turn it off.
3
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap and
the engine oil drain bolt to drain the
oil from the crankcase.
EAU1722A
1
2
3
4
5
6
7
8
9