Oven Vent; Baking; Outdoor Grill And Oven Care; Replacing The Igniter Battery - Jenn-Air FREESTANDING OUTDOOR GRILLS Installation Instructions And Use & Care Manual

Oven Vent

A
A. Oven vent
The oven vent is located on the oven back panel. The oven vent
releases hot air and moisture from the oven, and should not be
blocked or covered. Blocking or covering the oven vent will
cause poor air circulation, affecting cooking and cleaning results.
Do not set plastics, paper or other items that could melt or burn
near the oven vent.

Replacing the Igniter Battery

If igniters stop sparking, the battery should be replaced.
1. Open battery box cover on front of control panel.
2. Unscrew igniter cap counterclockwise to remove.
A. "AA" size battery
B. Igniter cap
3. Remove battery from the battery compartment.
4. Replace with a new alkaline "AA" size battery. Install battery
with negative end in first.
5. Screw igniter cap clockwise into place.
6. If necessary, repeat steps 1-5 for the other battery.

OUTDOOR GRILL AND OVEN CARE

A
B

Baking

Before baking, position the racks according to the "Positioning
Racks and Bakeware" section.
To Bake:
1. Push in and turn the oven control knob to the desired
temperature setting. The oven indicator light will turn on and
remain on until the oven reaches the set temperature.
2. Place food in oven. The burner will turn on and off to maintain
cooking temperature. The oven indicator light will turn on and
off with the burner.
3. Turn oven control knob to OFF when finished.

Changing the Grill Light Bulb

1. Unplug grill or disconnect power.
2. Make sure the light power switch on the control panel is in the
OFF position.
3. Use a Phillips screwdriver to remove the four screws securing
the light cover to the grill hood.
B
A
A. Remove these screws.
B. Light cover
NOTE: When removing final screw from the light cover, make
sure to hold the cover in place, ensuring it doesn't fall and
shatter.
A
29