Horizon Fitness EX-69 Owner's Manual page 14

AssEmBLY STEp 3
EX-79 SHOWN
All
MOdElS
noTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
14
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
AND WASHERS
MAIN FRAME
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
open hardware for step 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
Attach console mast to main frame
C
using pre-installed bolts and
washers.
slide wavy washer (l) over cranK
d
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the cranK using 1
E
flat washer (K), 1 spring washer (b)
WAVY WASHER (L)
and 1 bolt (m).
FLAT WASHER (K)
SPRING WASHER (B)
Repeat steps d–E on the opposite side of the
F
BOLT (M)
elliptical.
HARdWARE fOR STEp 3:
WAVY WASHER (L) BOLT (M) SPRING WASHER (B)
22.5 mm 20 mm 15 mm
Qty: 2 Qty: 2 Qty: 2
FLAT WASHER (K)
20 mm
Qty: 2