Bobbin Winding; Placing The Bobbin In The Machine - Husqvarna Platinum 730 User Manual

I n (sn l'IaOnuin
—
Place an empty bobbin on the
bobbin spindle at the front of the
machine (the mark facing
up).
Push the bobbin spindle down.
2
Place the large spool holder and a
felt pad under the spool on the auxi
lary spool pin.
3
Bring the thread into the thread ten
sion guide (a), and under thread
guide (b) then over thread guide (c)
as illustrated.
Placing the Bobbin in the Machine
Remove the bobbin cover by sliding
it
towards you.
2 Place the bobbin in the bobbin case with
the mark facing
up
and the thread to
the left of the bobbin. The bobbin will
then rotate counter clockwise when pull
ing out the thread.
3
Place your finger on the bobbin to keep
it
from turning as you pull the thread
firmly
to the right and then to the left
into the tension spring (a) until it "clicks"
into place.
4 Continue threading around (b) and to
the right of and then left into the thread
cutter (c). Replace the cover (1). Pull the
thread to the left to cut it (2).
Note: 1)epending on thread quality, take the
thread
one
or
two turns around the hohbin
thread tension
guide
(a).
4
From above wind a few
turns of
thread clockwise around the bobbin
and into the thread cutter (d).
S
Press the foot control. When the
bobbin is full, the winding will stop
automatically. Remove the bobbin
and cut off the thread. Bring the
bobbin spindle up.
Bobbin Winding