General Information - Jøtul GF 300 BV Allagash Installation And Operation Instructions Manual

General Information

THIS HEATER MUST BE INSTALLED AND MAINTAINED
BY A QUALIFIED SERVICE AGENCY.
The installation and repair of this appliance must be
done by a qualified service person. Failure to prop-
erly install and maintain this heater could result in
an unsafe or hazardous installation, which may result
in a fire, explosion, property damage, personal injury or
loss of life.
This appliance may be installed in an aftermarket
permanently located, manufactured (mobile) home,
where not prohibited by local codes.
This appliance is only for use with the type(s) of gas
indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certi-
fied kit is used.
Cet appareil peut être installé dans un maison
préfabriquée (mobile) déjà installée à demeure si les
règlements locaux le permettent.
Cet appareil doit être utilisé uniquement avec les
types de gas indiqués sur la plaque signalétique. Ne
pas l'utiliser ave d'autres gas sauf si un kitde conver-
sion certifié est installé.
This appliance should be inspected before use and at
least annually. More frequent cleaning may be
required due to excessive lint from carpeting,
bedding material, etc. It is imperative that control
compartments, burners, and circulating air passage-
ways of the appliance be kept clean.
THIS APPLIANCE MUST NOT BE CONNECTED TO A
CHIMNEY OR FLUE SERVING ANY OTHER APPLIANCE.
The installation must conform to local codes. Your
local Jøtul dealer can assist you in determining what
is required in your area for a safe and legal installa-
tion. Some areas require a permit to install a gas
burning appliance. Always consult your local build-
ing inspector, or authority having jurisdiction, to
determine what regulations apply in your area.
C C C C C ODE C ODE C ODE C ODE CO O O O O MPLIANC ODE C MPLIANCE: E: E: E: E: Your local officials have final MPLIANC MPLIANC MPLIANC
authority in determining if a proposed installation is
acceptable. Any requirement that is requested by
the local authority having jurisdiction, that is not
specifically addressed in this manual, defaults to
local code. In the absence of local codes, the installa-
tion requirements must comply with the current
edition of National codes. In the U.S., these require-
ments are established in the National Fuel Code,
ANSI Z223.1.(NFPA 54) current edition. In Canada, the
codes have been established in CAN/CGA B149 Fuel
Installation Code, current edition.
Consult the local or national installation code(s) to
assure that adequate combustion and ventilation air is
available.
Installer l'appareil selon les codes ou reglements
locaux, ou, en l'absence de tels reglements, selon les
Codes d'installation CAN/CGA-B149.
DO NOT OPERATE THIS STOVE IF ANY PART HAS BEEN
UNDER WATER. Call a qualified service technician to
inspect the heater and to replace any part of the
control system and any gas control which may have
been under water.
Ne pas se servir de cet appareil s'il a ete' plonge dans
l'eau, completement ou en partie. Appeler un
technicien qualifie pour inspecter l'appareil et
remplacer toute partie du syste'me de controle et
toute commande qui ont ete plonges dans l'eau.
Glass Panel
Do not operate this appliance with the glass
front removed, cracked, or broken. Replacement
of the glass should be done by a licensed or
qualified service person. Only remove glass for
routine service. Always handle glass carefully.
Unpacking your stove
1. Remove the Top Plate of the stove by simply lifting it
straight off of the stove body.
2. To open the firebox, disengage the two Glass Frame
Latches located on top of the firebox. Pull each handle
forward to clear the latch from the notch in the frame.
3. Familiarize yourself with the installation requirements
specified in this manual, before beginning the instal-
lation.
Hardware Bag Contents
• Fuel Conversion Kit - LP .................................. 155592
* Decorative Pipe Brackets.............................. 129469
Glass Frame
Latch
5