Optional Antique Brick Kit - Jøtul GF 300 BV Allagash Installation And Operation Instructions Manual

Optional Antique Brick Kit

# 155648
CAUTION!
THE BRICK PANELS AND LOG PARTS ARE EX-
TREMELY FRAGILE. HANDLE WITH CARE.
Read these instructions before beginning the installa-
tion.
1. Remove the Top Plate. Simply lift it up off of the
stove body. It is not fastened.
2. Remove the Glass Frame. Disengage the two com-
pression latches located at the top of the firebox and
lift the glass frame up and off of the stove. See fig. 39.
3. If installed, remove the Logset. These parts are not
fastened. Simply lift them out of the firebox. You do
not have to remove the embers.
4. Install the Lower Rear Panel. Position it up against
the back wall, resting on the burner skirt. Fig. 40.
5. Install a Side Panel. Tilt the panel, bottom edge first,
into position against the side wall. The panel will
stand on its own against the wall, fitting snugly
between the rear panel and the front wall of the
firebox. Fig. 41.
6. Install the Upper Rear Panel. Simply rest it on the
other two panels. Fig. 42.
7. Install the other Side Panel.
8. Reinstall the Logset. Refer to the Owner's Manual if
necessary. BE CERTAIN THAT NO EMBER STONES ARE
BLOCKING THE PILOT ASSEMBLY OPENING. Refer to
fig. 36.
9. Replace the Glass Frame. Slide the frame down the
slot in the front of the firebox. Be sure to push the
frame into the slot in the bottom to ensure it is fully
seated. The gasket at the top of the frame should be
flush with the top of the firebox.
Pull the compression latches out to engage with the
top lip of the glass frame.
10. Replace the Top Plate.
Upper Rear Panel
Left Panel
220998
Lower Rear Panel
Figure 38. Brick Kit Contents
22
220745
Right Panel
220999
220990
Figure 39.
Disengage the
compression latches
to remove the glass
frame.
Figure 40. Install Lower Rear Panel
Figure 41. Install Side Panel
Figure 42. Install Upper Rear Panel