Intermec EasyCoder PM4i User Manual page 75

Setup Mode; Serial Communication "uart2:" (option)
(Intermec Fingerprint v8.00)
SETUP:SETUP:
See Appendix C "Interfaces" for information on how the uart numbers relate to the physical communication ports.
SER-COM, UART2
SER-COM, UART2:
SER-COM, UART2:
PROT ADDR
BAUDRATE
PROT ADDR:
BAUDRATE;
DISABLE
DATA TO HOST:
9600 BAUDRATE;
ENABLE
19200 BAUDRATE;
38400
BAUDRATE;
Only displayed in case
57500 BAUDRATE;
of RS485.
115200 BAUDRATE;
300 BAUDRATE;
600
BAUDRATE;
1200 BAUDRATE;
2400 BAUDRATE;
4800
Menus inside this dotted box are not displayed in case of RS485 on "uart2:".
FLOW CONTROL:
ENQ/ACK
ENQ-ACK:
DISABLE ENQ/ACK:
ENABLE
SER-COM, UART2:
TRANS BUF
TRANS BUF:
[1024]:
Intermec EasyCoder PM4i User's Guide (Fingerprint version)
SER-COM, UART2: SER-COM, UART2:
CHAR LENGTH PARITY
CHAR LENGTH PARITY:
8 NONE
CHAR LENGTH PARITY:
7 EVEN
PARITY:
ODD
PARITY:
MARK
PARITY:
SPACE
FLOW CONTROL:
XON/XOFF
XON/XOFF: XON/XOFF:
DATA TO HOST DATA FROM HOST
DATA TO HOST: DATA FROM HOST:
DISABLE DISABLE
DATA TO HOST: DATA FROM HOST:
ENABLE ENABLE
SER-COM, UART2: SER-COM, UART2:
CONNECTED HW PROTOCOL ADDR.
CONNECTED HW: PROTOCOL ADDR.
RS232 [1]:
Only displayed in case of
Read-only
RS485 on "uart2:".
Enter printer's protocol
address (0–31).
Chapter 7 — Setup Mode
SER-COM, UART2: SER-COM, UART2:
STOP BITS FLOWCONTROL
STOP BITS: FLOW CONTROL:
1 STOP BITS: RTS/CTS
2
RTS/CTS:
DISABLE ENQ/ACK:
ENABLE
SER-COM, UART2: SER-COM, UART2:
NEW LINE REC BUF
NEW LINE: REC BUF:
CR/LF [1024]:
NEW LINE:
LF
NEW LINE:
CR
67