Description - Intermec EasyCoder PM4i User Manual

Chapter 6 — Setting Up the Printer

Description

The setup controls the printer in regard of serial communication, media
feed, and print speed, and specifi es which type of media and (optionally)
ribbon is loaded in the printer.
Check the list of the printer's default setup parameters on the next page
to see if they match your requirements. If not, you will have to change
the setup using one of the methods described below. The setup may also
be changed by Intermec PrintSet, InterDriver, and LabelShop, or third-
party application programs.
Setup Mode
• Press the <Setup> key on the printer's built-in keyboard to enter the
Setup Mode, or
• select the Setup option in Intermec Shell to enter the Setup Mode, or
• execute the Intermec Fingerprint
Setup Mode, or
• access the Setup Mode via the printer's home (requires an optional
EasyLAN interface board).
See Chapter 7, "Setup Mode" in this manual and the EasyLAN docu-
mentation.
Intermec Fingerprint
• Use setup strings to change individual setup parameters remotely
from the host, or
• use setup fi les to create sets of setup parameters remotely from the
host.
See the Intermec Fingerprint v8.00 manuals.
Intermec Direct Protocol
• Use setup strings to change individual setup parameters remotely
from the host.
See the Intermec Direct Protocol v8.00 manuals.
42
SETUP
Intermec EasyCoder PM4i User's Guide (Fingerprint version)
instruction to enter the