Assembly; Gearbox Assembly; Inspection - Invacare Spectra Blitz Service Instructions Manual

SERVICE MANUAL
· Remove the motor end (6) via the two cross point screws using a No 1 cross point screw driver.
· Remove the two/three electro magnetic brake (1) fixing screws and remove the brake.
· Remove the brush (2) feeder wire termination screws, release the brush springs and remove
the brushes (2).
20.3

Assembly

To reassemble reverse the steps 1 to 3, taking care not to damage the brushes and ensuring
correct alignment of the electro-magnetic brake.
· Should there be fitting, scoring or wear then replace the Motor Unit.
21

Gearbox Assembly

Description:
1 Gearbox Top
2 Gearbox Housing
3 Screws
4 Clutch Lever Upper
5 Clutch Lever Lower
6 Gearbox Top Gasket
7 Motor / Gearbox Gasket
8 Key
Requirements:
· 5mm hex wrench
· 8 mm open ended spanner
· Pin Hammer
· Punch
· Pliers
· Vice
21.1

Inspection

· Check casing for cracks or damage or leakages.
· Check gearbox for noises (gears and bearings).
· Check the declutching lever (4) and mechanism engages and disengages correctly.
40
®
Invacare - Spectra Blitz