Cub Cadet Domestic Series 7000 Service Manual page 39

3.8. Lift and support the front of the tractor by the dif-
ferential housing. Leave the hydraulic jack in
place. See Figure 3.8.
Figure 3.8
NOTE: If the MFD is being replaced because the
housing is broken, an alternative jacking point
may need to be identified by the technician.
3.9. Support the front cross-member of the tractor
frame on one or two jackstands.
3.10. Remove the front wheels using a 19 mm
wrench.
3.11. Remove the battery:
• Remove the wing-nuts and hold down bar that
secure the battery.
• Disconnect the negative terminal using a 3/8"
wrench.
• Disconnect the positive terminal using a 3/8"
wrench.
• Carefully lift the battery out of the tractor.
NOTE: Removing the battery yields access to
two of the bolts that hold the front MFD bracket.
Domestic Series 7000 MFD
3.12. Remove the four nuts that secure the front axle
bracket to the frame using a pair of 3/4"
wrenches. See Figure 3.12.
Front axle
mounting
bracket
3.13. Remove the four nuts that secure the rear axle
bracket (of the front axle) to the frame using a
pair of 3/4" wrenches. See Figure 3.13.
Rear axle
mounting bracket
3.14. Lower the MFD to the ground.
35
Bolts
(nuts removed)
Figure 3.12
Figure 3.13