Turn Signal/Multifunction Lever; Turn And Lane-Change Signals - Hummer H2 2009 Owner's Manual

Turn Signal/Multifunction Lever

The lever on the left side of the steering column
includes the following:
G : Turn and Lane Change Signals
5 3 : Headlamp High/Low-Beam Changer
N : Windshield Wipers
L
: Windshield Washer
Flash-to-Pass Feature
Information for these features is on the pages following.
3-8

Turn and Lane-Change Signals

Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. The turn signals automatically flash
three times. It will flash six times if the tow-haul mode is
active. Holding the turn signal lever for more than one
second causes the turn signals to flash until the lever
is released.
The lever returns to its starting position when it is
released.
If after signaling a turn or a lane change the arrows
flash rapidly or do not come on, a signal bulb may be
burned out.
Have the bulbs replaced. If the bulb is not burned out,
check the fuse. See Instrument Panel Fuse Block on
page 5-111 and Underhood Fuse Block on page 5-113.
An arrow on the instrument
panel cluster flashes in the
direction of the turn or
lane change.