Error Code
Description
E22
Fill timeout - No
fi ll/slow fi ll
E23
Flood protect
drain
E30
Drain pump not
present
E31
Drain timeout
E38
Dispenser error
E39
Dispenser timeout No switches
E42
Drive motor
- instantaneous
current
Error Codes
Problem
Fill time exceeds
•
Ensure manual water supply valves are fully open.
8 minutes.
•
Inspect inlet hoses for kinks/obstructions.
•
Inspect water valve screens for restriction.
•
Check water valve functions - t08 for hot water, t09
for cold water.
If above steps do not clear the problem replace solenoid
water valve.
F o a m s w i t c h
•
Check water valve functions - t08 for hot water, t09
closes in idle
for cold water.
state.
•
Check pressure switch foam contacts - t06 - fi rst
display should be E.
•
Off balance loads with heavy vibration can cause
code - retry before replacing any component.
Drain problems
•
Check drain pump - t05.
- no electrical
•
Check drain pump motor for open.
signal from
drain pump.
•
Check power to drain pump.
•
Check drain pump for stalling.
Slow drain
•
Check drain pump - t05.
- machine will
•
Check drain pump for restriction.
have water
- not full.
•
Check for drain restriction.
•
Drain height over 96-in. can cause code.
Correct
•
Check dispenser - t12 (Note: Do not unplug
reservoir is not
connectors from dispenser motor unless replacing.)
found and 8
switches are
seen when
motor is
running.
•
Check dispenser - t12 (Note: Do not unplug
found in 45
connectors from dispenser motor unless replacing.)
seconds.
Motor excess
•
Check drive motor - t10 tumble, t11 spin, t14 spin.
current draw.
•
Power down (unplug) washer, wait 30 seconds and
retry. If code reoccurs, check drive motor windings.
If motor windings OK, replace inverter. (You may see
a burned spot on inverter.) (Note: Cannot occur with
open motor winding.)
– 53 –
Possible Cause/Action
(Continued Next Page)