Door Lock; Programming The Control Board - GE WBVH6240 Technical Service Manual

To remove the control board assembly:
1. Remove the control panel. (See
2. Pull the cycle knob off.
3. Remove the 4 Phillips-head screws that hold the
control board assembly to the control panel.
4. Release the 3 tabs at the bottom of the control
panel.
Tabs
5. Remove the control board assembly from the
control panel.
6. Remove the cycle selection buttons.
Note:
• The replacement control board will always enter
into test mode t01 on initial power-up.
• If replacing the control board, the washer will
not function until the replacement control board
has been programmed.

Programming the Control Board

To program the replacement control board:
1. Reconnect power to the washer. (The display
will now show "---", which means no model has
been selected.)
2. Rotate the cycle knob until the correct model
number is displayed:
• Select 1 for model WHDVH626F
• Select 2 for model WCVH6260F
• Select 3 for model WBVH6240F
3. Press and hold the Start key for 3 seconds (or
until a second beep is sounded).
4. Press the Power key to reset the control.
Note: If an error is made in programming the
control, enter test mode and select t01. Then repeat
steps 2 thru 4.

Door Lock

.)
Control Panel
The door lock contains a door switch and solenoid
operated locking and unlocking mechanism. A
release ring, located at the bottom, allows for
manual unlocking of the door.
The door locks when a cycle is entered (Wake-up
routine) and during every cycle. The door unlocks at
the completion of a cycle.
The door will not open when:
• The foam switch is open
• Water temperature is above 130°F (54°C)
• Wash basket is rotating
Specifi c failures associated with the door lock can
initiate error codes E60 thru E64. (See
Mode
The door lock is held to the front panel with 3
Phillips-head screws. The door lock is accessed from
the front of the washer when the right side of the
gasket is partially pulled back.
To remove the door lock :
1. Remove the 3 Phillips-head screws that hold the
door lock to the front panel.
– 26 –
.)
Service Test
(Continued Next Page)