Frequency Priority Selection - Toshiba TOSVERT VF-S11 Instruction Manual

Setting of switching terminals
The terminal for switching to motor 2 needs to be set, since this function is not assigned under the default
setting. Assign this function to an idle terminal.
The parameters to be switched depend on the particular identification number of the input terminal selection
function. (Refer to K-15.)
AD2
OFF
OFF
OFF
6
6.5

Frequency priority selection

6.5.1
• Function
Input terminal function number
5 39 40
VF2 MOT2
OFF OFF
ON OFF OFF
- OFF OFF
OFF OFF
ON OFF
- - ON
Using a frequency command according to the particular
situation
: Frequency setting mode selection 1
: Frequency priority selection
: Speed setting mode selection 2
These parameters are used to switch between two types of frequency command signals.
• Setting by parameters
• Switching by frequency
• Switching via terminal board input
58 61 Parameters used and applicable parameters
AD3 OCS2
OFF OFF Default setting:
,
OFF OFF
ON OFF
OFF ON
OFF OFF
OFF -
F-16
, , , , ,
,
,
,
,
,
E6581158
,