Linksys 900 Series Administrator's Manual page 57

Chapter 3 Managing Linksys 900 Series IP Phones
d5=<language5>;x5=<dictionary5 filename>;
d6=<language6>;x6=<dictionary6 filename>;
d7=<language3>;x7=<dictionary7 filename>;
d8=<language8>;x8=<dictionary8 filename>;
d9=<language5>;x9=<dictionary9 filename>;
The following is an example value:
<Dictionary_Server_Script ua="na">
serv=tftp://192.168.1.119/;d0=English;x0=enS_v101.xml;d1=Spanish;x1=esS_v101.xml
</Dictionary_Server_Script>
•
Language Selection—This parameter is used to select the default language. Its value needs to match
one of the languages supported by the dictionary server. The script (dx value) is as follows:
<Language_Selection ua="na">
</Language_Selection>
The default is blank and the maximum number of characters is 512. The following is an example:
<Language_Selection ua="na"> Spanish
</Language_Selection>
These parameters can also be modified from the administration web server, on the
Regional settings tab, as shown in
Figure 3-3
During startup, the phone checks the selected/preferred language and downloads the dictionary
from the TFTP/HFTP provisioning server indicated in the device configuration. The
dictionaries are available at the following website:
http://www.linksys-itsp.com
The dictionaries are found in the FW and Tools section, LVS area. Currently dictionaries are
available for the following languages:
•
English
•
Spanish
•
German,
•
Dutch
•
Italian
•
French
•
Portuguese
•
Danish
Document Version 3.1
Dictionary Server Configuration Parameters
Figure 3-3.
Linksys 900 Series IP Phone Administrator Guide
Localization
3-7