Advertisement
C27
I
Secure the motor by tightening the 2 screws.
C29
O N
O F F
Test the motor. If the motor does not run, check the plug
connection.
Existing Construction – accessible only from below
D11
EXISTING FAN
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new motor
housing (9" x 9.75").
14
C28
Turn on the power source.
C30
Go to step
E1
on page 17
to attach grille.
D12
E
Move the housing into position above the ceiling.
41721-01 12/25/2004
D13
.
Pull wires through strain relief
D15
E
Screw pre-loaded screws into joist or framing.
D17
F
Install the wiring cover plate. Make sure all
wiring connections are inside the box or under
the wiring cover plate.
41721-01 12/25/2004
D14
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
D16
Ground
Green
A
Bare Copper
A
A
Black
White
Connect wires as shown.
D18
B
D
G
•
Tighten the wiring cover plate screw.
15
Advertisement
