Advertisement
B23
Connect wiring from the motor to the wiring cover plate.
B25
I
Secure the motor by tightening the 2 screws.
B27
O N
O F F
Test the motor. If the motor does not run, check the plug
connection.
10
B24
H
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
B26
Turn on the power source.
B28
Go to step
E1
on page 17
to attach grille.
41721-01 12/25/2004
Existing Construction – accessible from above
C11
EXISTING FAN
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new
motor housing (9" x 9.75").
Cut out an opening for the housing.
C13
5/8
1/2
Position the correct depth mark at the bottom edge of the
joist based on the thickness of your sheetrock.
41721-01 12/25/2004
NO EXISTING FAN
OR
Use the motor housing as a template to mark position.
C12
D
Slide the mounting rails into brackets.
C14
D
5/8
1/2
Mark position of screws by using holes as a template.
11
Advertisement
