Advertisement
C15
Drill a hole in the center of each outline.
C17
Attach the rails onto the screws.
C19
Connect 4" duct and vent to the outside. Tape joints.
If ducting does not fit securely, an adapter may
need to be purchased.
12
C16
Insert screws, leaving space between the screw head
and the joist. Screws are not provided.
C18
Tighten screws.
C20
Pull wires through the strain relief.
41721-01 12/25/2004
C21
Tighten the strain relief screws.
C23
F
Install the wiring cover plate. Make sure all
wiring connections are inside the box or under
the wiring cover plate.
C25
Connect wiring from the motor to the wiring cover plate.
41721-01 12/25/2004
C22
Ground
Green
A
Bare Copper
A
A
Black
White
Connect wires as shown.
C24
B
D
G
•
Tighten the wiring cover plate screw.
C26
H
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
13
Advertisement
