Speed Control - Hunter TYPE 2 Installation Instructions

STEP 10: OPERATION OF FAN
A. TURN ELECTRICAL SERVICE ON AT MAIN PANEL.
B. SWITCH OPERATES IN THIS SEQUENCE: "HIGH," "MEDIUM," "LOW," "OFF." PULL CHAIN SLOWLY TO OPERATE.
ALSO, RELEASE THE CHAIN SLOWLY SO AS TO PREVENT CHAIN FROM FLYING UP INTO BLADES,
POSSIBLY RESULTING IN DAMAGE TO BLADES OR PULL CHAIN. THE BREAKAWAY CONNECTOR IS DESIGNED
TO SEPARATE FROM THE CHAIN AT A PREDETERMINED FORCE. IF THIS SEPARATION OCCURS,
SIMPLY REINSERT THE CONNECTOR. IT CAN BE USED AGAIN AND AGAIN. SEE FIGURE 9.
C. MOTOR IS ELECTRICALLY REVERSIBLE. WHEN FIRST OPERATING FAN, DETERMINE DIRECTION OF AIR
FLOW. IF YOU WISH TO CHANGE DIRECTION, SWITCH FAN OFF AND ALLOW TO STOP. SLIDE REVERSING
SWITCH TO THE OPPOSITE POSITION AND SWITCH FAN BACK ON. SEE FIGURE 9.
EXTENSION PIPES
IF YOUR CEILING IS HIGHER THAN EIGHT FEET, YOU MAY ELECT TO USE A LONGER HANGER PIPE.
EXTENSION PIPES ARE AVAILABLE AT YOUR HUNTER DEALER AND MAY BE ADAPTED TO FIT YOUR FAN.

SPEED CONTROL

AS AN OPTION, A WALL MOUNTED SPEED CONTROL SWITCH IS AVAILABLE FROM YOUR HUNTER DEALER.
TROUBLESHOOTING GUIDE
PROBLEM
1. NOTHING HAPPENS
FAN DOES NOT MOVE.
*NOTE: IF BLADES WILL NOT TURN BY HAND, CONTACT YOUR NEAREST SERVICE REPRESENTATIVE.
2. NOISY OPERATION.
3. EXCESSIVE WOBBLING.
WHEN SWITCHING FROM MEDIUM TO LOW SPEED, YOU MAY NOTICE SOME FAN WOBBLE. WHEN FAN SPEED STABILIZES AT LOW
SPEED, WOBBLE WILL DISAPPEAR. IF YOU HAVE CHECKED THE ABOVE PROBLEMS AND STILL HAVE TROUBLE, CALL (901) 745-9222.
C 1989 HUNTER FAN COMPANY
PROBABLE CAUSE
1. POWER TURNED OFF OR FUSE BLOWN.
*
2. LOOSE WIRE CONNECTIONS OR
WRONG CONNECTIONS.
3. MOTOR REVERSING SWITCH NOT ENGAGED.
4. PULL CHAIN SWITCH NOT "ON".
1. BLADE BRACKETS LOOSELY SCREWED TO MOTOR.
2. BLADE SCREWED LOOSELY TO BLADE BRACKET.
3. BLADE CRACKED.
4. NON-APPROVED SPEED CONTROL BEING USED.
5, GLOBE IS VIBRATING AND EMITTING NOISE.
1. UNBALANCED BLADES.
2. FAN TOO CLOSE TO VAULTED CEILING.
3. LOOSE BLADES OR BLADE BRACKETS.
4. FAN NOT SECURE ON HANGER ASSEMBLY.
TM
SOLUTION
1. TURN POWER ON OR REPLACE FUSE.
2. LOOSEN CANOPY, CHECK ALL CONNECTIONS (TURN
POWER OFF WHILE CHECKING).
3. PUSH SWITCH FIRMLY TO ONE SIDE OR THE OTHER.
4. PULL SWITCH CHAIN.
1. TIGHTEN SCREWS UNTIL SNUG.
2. TIGHTEN SCREWS.
3. REPLACE ENTIRE SET OF BLADES.
4. CHANGE TO APPROVED SPEED CONTROL.
5. RE-ADJUST 3 GLOBE MOUNTING SCREWS.
1. USE BALANCING KIT (SEE STEP 8C).
2. LOWER OR MOVE FAN.
3. TIGHTEN ALL SCREWS.
4. TURN POWER OFF, SUPPORT FAN VERY CAREFULLY,
LOOSEN CANOPY AND HANG CORRECTLY.
SINCE 1886
REV: 5/94
HUNTER FAN COMPANY
2500 FRISCO AVENUE
MEMPHIS, TN 38114
R
FORM NO. 40987-01
PAGE 5