Speed Control; Troubleshooting Guide - Hunter 23710 Installation Instructions Manual

Step 10: Install Globes
Install the globes to the light fixture by inserting the neck of the
globe into the fixture fitter and securing the globe in place by
tightening the (3) thumb screws. See Figure 11.
LIGHT ON-OFF
SWITCH
THUMB
SCREWS
CAUTION: Use maximum 60 Watt 120 Volt lamps.
Use decorative lamp type B-10.
PROBLEM
1. Nothing happens
fan does not move.*
*NOTE: If blades will not turn by hand, contact your nearest service representative.
2. Noisy operation.
3. Excessive wobbling.
When switching from medium to low speed, you may notice some fan wobble. When fan stabilizes at low speed, wobble will disappear.
FORM NO. 41184-01 10/05
FIXTURE
FITTER
GLOBE
Figure 11

TROUBLESHOOTING GUIDE

PROBABLE CAUSE
1. Power turned off or fuse blown.
2. Loose wire connections or wrong
connections.
3. Motor reversing switch not engaged.
4. Pull chain switch not "ON".
5. Rubber shipping blocks not removed.
1. Blade brackets loosely screwed to motor.
2. Blade screwed loosely to blade bracket.
3. Blade cracked.
4. Non-approved speed control being used.
5. Light globe noisy.
1. Blade brackets not attached at proper
locations.
2. Unbalanced blades.
3. Fan to close to vaulted ceiling.
4. Loose blades or blade brackets.
5. Fan not secure on hanger assembly.
Step 11: Operation of Fan
A.
Turn electrical service on at main panel.
B.
Fan switch operates in this sequence: "High," "Medium,"
"Low," "Off." Pull chain slowly to operate. Also, release the
chain slowly so as to prevent chain from flying up into blades,
possibly resulting in damage to blades, or pull chain. The break-
away connector is designed to separate from the chain at a pre-
determined force. If this separation occurs, simply reinsert the
connector. It can be reused again and again. See Figure 10.
The light on/off pull chain switch is located in the switch hous-
ing. See Figure 11.
C.
Motor is electrically reversible. When first operating fan,
determine direction of air flow. If you wish to change direction,
switch fan off and allow to stop. Slide reversing switch to the
opposite position and switch fan back on. See Figure 10.

Speed Control

As an option, a wall mounted speed control switch is available
from your Hunter dealer.
SOLUTION
1. Turn power on or replace fuse.
2. Loosen canopy, check all connections
(turn power off while checking).
3. Push switch firmly to one side or the other.
4. Pull switch chain.
5. Remove shipping blocks.
1. Tighten screws until snug.
2. Tighten screws.
3. Replace all blades.
4. Change to approved speed control.
5. Adjust globe mounting screws.
1. Carefully review Step 8.
2. Use balancing kit. (See Step 8C.)
3. Lower or move fan.
4. Tighten all screws.
5. Turn power off, support fan very carefully,
loosen canopy and hang correctly.
- -
5
©2005 HUNTER FAN CO.