Ricoh Aficio 1224C Settings Manual page 116

Troubleshooting
Machine Status
The main power indicator
continues blinking and
does not turn off when
pressed.
The original images are
printed on the reverse side
of the paper.
Misfeeds occur frequently.
6
An error message remains,
even if misfed paper is re-
moved.
Cannot print in duplex
mode.
100
Problem/Cause
This occurs in the follow-
ing cases:
• The exposure glass cov-
er or document feeder
(ADF) is open.
• The machine is in com-
munication with exter-
nal equipment.
• The hard disk is in op-
eration.
You may have loaded the
paper incorrectly.
The tray's side guides may
not be locked.
The tray's end guide may
not be locked.
You may have loaded pa-
per whose size cannot be
detected automatically.
When a misfeed message
appears, it remains until
you open and close the cov-
er, as required.
You cannot use the paper
in the bypass tray for du-
plex printing.
If you select thick paper,
thick dup. back paper,
OHP or label paper as the
paper type, duplex print-
ing is disabled.
The setting for the Paper
Type: Tray 1-4 is "1 Side
Copy".
Action
Wait till the blinking stops, and then
turn off the operation switch.
Load paper into trays 1, 2, 3, and 4,
and the large capacity tray with the
print side up, or into a bypass tray
with the print side down. ⇒ p.102
"B Loading Paper"
Check that the side guides are
locked. ⇒ p.112 "Changing the Pa-
per Size"
Check that the end guide is locked.
⇒ p.112 "Changing the Paper Size"
When you use paper of a size that
cannot be detected automatically,
set the paper size. ⇒ p.65 "Tray Pa-
per Size: (Tray 1–4)" ⇒ p.144 "Copy
Paper"
Clear misfed paper and open and
close the front cover. ⇒ p.107 "x
Clearing Misfeeds"
For duplex printing, select Tray 1 - 4
in Copier mode or with the printer
driver.
Select another paper type. ⇒ p.65
"Tray Paper Size: (Tray 1–4)"
Select "2 Sided Copy" for Paper
Type:Tray 1-4 ⇒ p.65 "Tray Paper
Size: (Tray 1–4)"