Yamaha YZFR1W 2007 Service Manual page 95

5. Drain:
• Engine oil
(completely from the crankcase)
6. If the oil filter cartridge is also to be
replaced, perform the following procedure.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the oil filter cartridge "1" with an oil
filter wrench "2".
Oil filter wrench
90890-01426
YU-38411
b. Lubricate the O-ring "3" of the new oil filter
cartridge with a thin coat of engine oil.
ECA13390
CAUTION:
Make sure the O-ring "3" is positioned cor-
rectly in the groove of the oil filter car-
tridge.
c. Tighten the new oil filter cartridge to speci-
fication with an oil filter wrench.
Oil filter cartridge
17 Nm (1.7 m·kg, 12 ft·lb)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
7. Check:
• Engine oil drain bolt gasket
8. Install:
• Engine oil drain bolt
(along with the gasket)
Engine oil drain bolt
43 Nm (4.3 m·kg, 31 ft·lb)
9. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Engine oil quantity
Total amount
3.83 L (4.05 US qt) (3.37
Imp.qt)
Without
replacement
2.90 L (3.07 US qt) (2.55
Imp.qt)
With oil filter cartridge replace-
ment
3.10 L (3.28 US qt) (2.73
Imp.qt)
10. Install:
• Engine oil filler cap
• Lower cowlings
Refer to "GENERAL CHASSIS" on page 4-
1.
11. Start the engine, warm it up for several
minutes, and then turn it off.
12. Check:
• Engine
(for engine oil leaks)
3-12
ENGINE
New
oil filter cartridge