Yamaha YZFR1W 2007 Service Manual page 179

a. Remove the rod puller attachment.
b. Install the nut.
c. Install the fork spring and spacer.
NOTE:
Install the spring with the smaller pitch "a" fac-
ing up "A".
d. Reinstall the rod puller attachment
e. Press down in the spacer with the fork
spring compressor "1"
f. Pull up the rod puller and install the rod
holder "2" between the damper adjusting
rod locknut "3" and the spacer "4".
NOTE:
Use the side of the rod holder that is marked
"A".
Rod puller
90890-01437
Universal damping rod bleeding
tool set
YM-A8703
Rod puller attachment (M12)
90890-01435
Universal damping rod bleeding
tool set
YM-A8703
Fork spring compressor
90890-01441
YM-01441
Rod holder
90890-01434
Damper rod holder double
ended
YM-01434
g. Remove the rod puller and the rod puller
attachment.
h. Install the nut "1" and position it as speci-
fied "b".
Distance "b"
11 mm (0.43 in)
i. Set the cap bolt distance "c" to specifica-
tion.
Distance "c"
13 mm (0.51 in)
j. Install the damper adjusting rod and cap
bolt, and then finger tighten the cap bolt.
k. Hold the cap bolt and tighten the damper
adjusting rod locknut to specification.
Damper adjusting rod locknut
29 Nm (2.9 m·kg, 21 ft·lb)
l. Remove the rod holder and fork spring
compressor.
4-57
FRONT FORK