Table of Contents
Advertisement
Voiding the standard key code:
If a standard key has been lost, it is possible to disable its use by re-registering the remaining stan-
dard key. Standard key registration erases the stored standard key code from the memory, thus dis-
abling the lost standard key.To re-register, refer to "Standard key registration".
Standard key code voiding method
a. Main switch "ON"
b. Main switch "OFF"
c. LED on
d. LED off
e. Less than 5.0 s
f. Code re-registering key
EAS27701
TROUBLESHOOTING
When the main switch is turned to "ON", the immobilizer system indicator light does not come on nor
flashes.
1 Check the fuses.
(Main, ignition and backup)
Refer to "CHECKING THE FUSES"
on page 8-85.
OK↓
2 Check the battery.
Refer to "CHECKING AND
CHARGING THE BATTERY" on
page 8-85.
OK↓
3 Check the main switch.
Refer to "CHECKING THE
SWITCHES" on page 8-81.
OK↓
IMMOBILIZER SYSTEM
g. Remaining standard key
h. Registration mode
A. If the immobilizer system indicator light
stops flashing 5 seconds after the first stan-
dard key is registered, the second standard
key cannot be registered.
NG→
Replace the fuse(s).
NG→
• Clean the battery terminals.
• Recharge or replace the battery.
NG→
Replace the main switch/immobilizer
unit.
8-74
Advertisement
Chapters
Table of Contents
