Yamaha YZFR1W 2007 Service Manual page 418

EAS28390
CHECKING THE CYLINDER IDENTIFICA-
TION SENSOR
1. Check:
• Cylinder identification sensor output volt-
age
Out of specification → Replace.
Cylinder identification
output voltage
When sensor is on
4.8 V or more
When sensor is off
4.8 V or less
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the pocket tester (DC 20 V) to the
cylinder identification sensor coupler (wire
harness side) as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
White/Black "1"
• Negative tester probe
Black/Blue "2"
b. Set the main switch to "ON".
c. Rotate the crankshaft.
d. Measure the voltage (DC 20 V) of White/
Black and Black/Blue. With each full rota-
tion of the crankshaft, the voltage reading
should cycle from 0.8 V to 4.8 V to 0.8 V to
4.8 V.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS28410
CHECKING THE INTAKE AIR PRESSURE
SENSOR
1. Check:
• Intake air pressure sensor output voltage
Out of specification → Replace.
ELECTRICAL COMPONENTS
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the pocket tester (DC 20 V) to the
intake air pressure sensor coupler (wire
sensor harness side) as shown.
• Positive tester probe
Pink/White "1"
• Negative tester probe
Black/Blue "2"
b. Set the main switch to "ON".
c. Measure the intake air pressure sensor
output voltage.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS28420
CHECKING THE INTAKE AIR TEMPERA-
TURE SENSOR
1. Remove:
• Intake air temperature sensor
(from the air filter case.)
EWA14110
WARNING
• Handle the intake air temperature sensor
with special care.
• Never subject the intake air temperature
sensor to strong shocks. If the intake air
temperature sensor is dropped, replace it.
2. Check:
• Intake air temperature sensor resistance
Out of specification → Replace.
8-99
Intake air pressure sensor out-
put voltage
3.15–4.15 V
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C